Mounting - Cardinal 190 Installation, Technical And Operation Manual

Mounting

Before beginning the installation of your Model 190 Indicator, make certain that it has been
received in good condition. Carefully remove it from the shipping carton and inspect it for any
evidence of damage (such as exterior dents or scratches) that may have taken place during
shipment. Keep the carton and packing material for return shipment if it should become
necessary. It is the responsibility of the purchaser to file all claims for any damages or loss
incurred during transit.
NOTE: Should your Model 190 indicator come already installed on a scale, the following
information describing the installation of the indicator does not apply.
The Model 190 indicator is housed in a Thermoplastic IP69K wall or desk-mount enclosure.
The gimbal may be mounted on a desktop or other smooth, flat, horizontal surface or may be
mounted on a wall. Refer to Figure No. 1 for a layout of wall-mounting bolts.
Figure No. 1
If wall-mounted, make certain the mounting surface is strong enough to support the indicator.
The mounting location should be where the display is easily viewed while being close enough
to provide the operator easy access to the keypad. Carefully lay out the mounting hole
locations, then drill and install the anchor bolts. Attach the gimbal to the wall and securely
tighten the retaining bolts.
6.00"
8400-M022-O1 Rev K  Model 190 Indicator
Clearance for
#10 size screw
7