Cardinal 190 Installation, Technical And Operation Manual page 102

aUto= (Automatic Axle Weigher)
The aUto= (Automatic Axle Weigher) prompt determines whether the scale will be an
automatic axle weigher or will function as a standard axle weigher, using the PRINT / Fn
PRINT key functions
Press the TARE  key to show the current setting. If the setting displayed is acceptable,
press the TARE  key again to save it. Otherwise, use the Fn/ key to toggle to a new
setting and press the TARE  key to save it.
aUto=YES
The scale will be an
automatic axle weigher
When AUTo=YES, the following additional prompts will be displayed.
tHrS= (Threshold Weight)
The user can enter a one-to-six-digit number. This value will be the threshold weight or trip
point above which the system will consider a truck to be on the scale.
Press the TARE  key to show the current setting. If the setting displayed is acceptable,
press the TARE  key again to save it. Otherwise, use the Fn/ and UNITS/ keys to
enter a new setting and press the TARE  key to save it. Allowable values for threshold
weight are 1 through 999,999.
SdLy= (Stoplight Delay)
This value is the number of seconds the stop light will stay on (red) before turning back to
green following a printing, to allow the user to proceed to the next axle.
Press the TARE  key to show the current setting. If the setting displayed is acceptable,
press the TARE  key again to save it. Otherwise, use the Fn/ and UNITS/ keys to
enter a new setting and press the TARE  key to save it. Allowable values for the stoplight
delay are 1 to 99 seconds.
tdLy= (Total Delay)
This value is the number of seconds between when the scale weight falls below tHrS
(threshold weight) and the automatic TOTAL print starts.
Press the TARE  key to show the current setting. If the setting displayed is acceptable,
press the TARE  key again to save it. Otherwise, use the Fn/ and UNITS/ keys to
enter a new setting and press the TARE  key to save it. Allowable values for the total
delay are 1 to 99 seconds.
NOTE: The Total Delay timer will start after the Stoplight Delay timer expires.
94
aUto=no
The scale will be a
standard axle weigher
8400-M022-O1 Rev K  Model 190 Indicator