OmniCell ERB Installation And Service Manual page 93

5. Disconnect J1, J2, and J3 connectors.
J1
J2
Figure 3-10. J connector locations
6. Remove the four
7. Replace the PCB.
Figure 3-11. Screw locations
8. Secure the new PCB with the 4-40 SOC screws.
9. Maneuver the metal mount back into position.
10. Tighten the two nuts on either side of the plate.
11. Close the return door.
12. Lock up the ERB.
© 2011 Omnicell, Inc.
J3
4-40 SOC screws.
External Return Bin Installation and Service Guide/67-2038 Rev D
Service 3-5
Printed Circuit Board (PCB)