OmniCell ERB Installation And Service Manual page 16

2-6 Installation Instructions
Setup
12. Cover the gray PowerCom cable with the black grommet taken off in
grommet together and push through the double D cutout on the left side.
Figure 2-14. Securing the grommet around the PowerCom cable
13. Snap the plug cover into the left-side D cutout adjacent to the cable assembly. The plug covers
the opening which will be used for future hardware developments.
Figure 2-15. Snapping in the plug
14. Rotate the lower plates. The open side of the left lower plate should face left. The open side of
the right lower plate should face down. This allows the left cover plate to protect the cables
being routed out of the ERB. The right cover plates will seal the cable openings on the right
side of the ERB.
Figure 2-16. Orientation for left cover plates
External Return Bin Installation and Service Guide/67-2038 Rev D
step 9. Squeeze the
© 2011 Omnicell, Inc.