Table of Contents
Advertisement
8. Remove the gray PowerCom cable from the right side of the ERB and set it aside.
Figure 2-11. Removing the PowerCom cable
9. Squeeze and pull the black
10. Remove the black
Figure 2-12. Removing the plug cover
11. Thread the PowerCom cable through the rear cutout on the opposite side of the ERB. T he
correct orientation of the cable assembly exiting from the left side of the ERB is shown in the
figure below.
Figure 2-13. PowerCom cable routing
© 2011 Omnicell, Inc.
grommet
to remove it from the opening.
plug cover
by pushing against the groove from the inside with a screwdriver.
External Return Bin Installation and Service Guide/67-2038 Rev D
Installation Instructions 2-5
Setup
Advertisement
Table of Contents
