OmniCell ERB Installation And Service Manual page 34

2-24 Installation Instructions
Installation on G3 Cabinets
4. Disconnect the 4-pin
Figure 2-61. The original AUX cable assembly removed
5. Install the
Figure 2-62. New AUX connector
6. Insert the 4-pin connector into the AUX COM connection on the PowerCom board.
Figure 2-63. 4-pin connection location for the PowerCom cable
7. Plug in the 3-pin connector with the blue and yellow cables on the
into J16 (labeled MAG) on the PowerCom board.
8. Pull the ERB cable through the ERB connection opening.
9. Slip on the
External Return Bin Installation and Service Guide/67-2038 Rev D
PowerCom cable,
AUX connector from the ERB kit.
metal retainer over the ERB cable inside the PC box.
then remove the AUX cable assembly.
retrofit AUX cable assembly
© 2011 Omnicell, Inc.