Sensor/S - GRAUPNER MC-20 HoTT Programming Manual

programming, such as fail-safe settings,
disconnect the three-pole satellite connection
between the two receivers and switch on only
the relevant receiver. It may be necessary to also
change the connection sequence.
Setting/displaying sensors
If, in addition to a "receiver", at least one sensor
is selected in the »Telemetry« menu's »SENSOR
SELECT« sub-menu (described below) then
its settings can be read in and changed on the
previously described receiver screens.
However, to actually gain access to this data, the
selected sensor/s must be connected to the receiver
system and this receiver system must have an active
telemetry connection.
If, as described in the next section, there is at least
one sensor activated which has the support of current
fi rmware, then it is possible to directly switch between
individual modules. However, if sensors with older
fi rmware are in use, it may be necessary to select
"etc." instead of the direct sensor selection.
In either case, tap the or selection key of the left
touch pad ...
VARIO
RECEIVER
etc.
... then use the same keys to select up or down for
the desired module, for example:
GPS
VARIO
Receiver
If the selected module, in this case a Vario module,
is active then on the last receiver screen ("RX
SERVO TEST"), at the top right there will also be
an additional " " symbol pointing to the right. This
symbol is located just to the right of the left-pointing "
" symbol and is the visible indicator that additional
display screens can be accessed.
TELEMETRY
RX SERVO TEST VOLT.E
TELEMETRI RCV ALL–MAX : 2000 sec
ALL–MIN : 1000 sec
SETTING & DATAVIEW
TEST : START
ALARM VOLT : 3.8V
SENSOR SELECT
ALARM TEMP+: 70°C
RF STATUS VIEW
ALARM TEMP–:–10°C
CH OUT TYPE:ONCE
VOICE TRIGGER
Now use one of the selection keys on the left or
right touch pad to switch to the selected sensor's
displays and check or change its settings as
described in the manual delivered with the sensor.
BIND. 1
Detail program description - Telemetry
239