Multichannel - GRAUPNER MC-20 HoTT Programming Manual

• The settings made in the "POS" value fi eld
replace the otherwise "conventional" transmitter
control signal. Therefore it is necessary, before
programming such a sequence, to check in the
»Servo display« menu to make sure none of the
channels planned for the sequence are actuated
by any other transmitter operating element. If this
were to be the case, it could lead to unpredictable
excursions in the motion sequence.
• The settings made in the » Servo adjustment«
and »Tx. output swap« menus are not affected
by settings in this menu.
• When preparing and creating a sequence,
be absolutely sure the servos do not collide
mechanically. If necessary, use the "Travel limit"
option in the »Servo adjustment« menu.
246 Detail program description - Channel sequencer
Multi-channel
Channel multiplier for special functions
mc-20
The HoTT transmitter has an integrated multi-
function channel built into the transmitter's software.
This facility permits up to two control channels to be
used for up to four or eight special functions Every
available switch (including the so-called expansion
switches, see page 56) or transmitter control can be
assigned on the transmitter side.
On the receiver side, the following modules are
available as accessories, whereby at one time a
maximum of two modules can be operated via the
»Multi-channel« menu.
NAUTIC-Expert, switching module, order no. 4159
The NAUTIC-Expert switching module expands a
servo's functionality to 16 switched functions. By
appropriately wiring the connecting cable, loads can
either be operated from a common power supply or
also separately by multiple power sources.
NAUTIC-Multi-Prop mini-decoder order no. 4142.N
The 1/4 C-NAUTIC-Multi-Prop mini-decoder expands
a proportional function to four proportional functions.
Light module order no. 2381
A module for switching the light signals of rail, road
and airborne vehicles with true authenticity.
Sound switch for vehicle models order no. 2382.F
start, stop and supplementary sounds as well as
typical vehicle signals
Sound switch for ship models order no. 2382.S
start, stop and supplementary sounds as well as
typical ship signals
Further information can be found in Internet at
www.graupner.de. Use the search mask by entering
the respective order no. Alternatively, contact or visit
your local dealer.
Use the selection keys on the left or right touch pad
to scroll to the menu option »Multichannel« menu
option in the multi-function menu: