Table of Contents
Advertisement
Importing from SD card
Use the
selection keys of the left or right touch
pad to select the »Import from SD« sub-menu then
tap on the
SET
key.
Erase model
Copy modell –> Modell
Please select
RF on/off?
Expor t to mnach SD-Kar te
=>
Impor t from von SD-Kar te
Copy flight sen kopieren
ON
OFF
If the message shown above should appear, the
transmitter's RF module is still active. Switch the RF
module off as described on page 80 then also, if a
receiver system is currently switched on, switch off that
receiver too. This is to be done for reasons of safety.
Select the model to be imported from the SD memory
card with the
selection keys of the left or right
touch pad.
impor t from SD-CARD:
01
Soarmaster
11/06/06 06:06
02
Extra 300
11/07/07 07:07
03
T-Rex 250
11/08/08 08:08
04
11/09/09 09:09
BellCobra
Note:
The export date posted at the right end of each model
name line is represented in the format "year/month/
day".
After another tap on the
SET
key of the right touch
pad, the "import from SD-CARD" window will appear.
Now the destination memory location can be selected
with the
selection keys of the left or right touch
72
Detail program description - Copy / Erase
pad then confi rmed with a tap on the
process can be canceled with a tap on the
A memory location which is already occupied can be
overwritten.
Impor t to model:
01
Graubele
1234g/080811
02
Ultimate
Test
03
Starlet
trim needed
04
BELL47G
05
free
After confi rming the selected model memory with a tap
on the
SET
key, a confi rmation request will appear:
model
Extra 300
05
free
impor t?
NO
A
NO
response will cancel the process and return
the screen to the originating screen. If the
response is selected and confi rmed with a tap on
the
SET
key then the selected source model will be
imported into the selected destination model memory.
Notes:
•
If the message ...
SD-CARD
INSERT
OK
... appears instead of a screen for model
selection, there is no SD card in the transmitter's
SET
key, or the
card slot, see page 23.
ESC
key.
•
In addition to model data, binding data is also
imported by this process. This means that a
receiver system which was/is bound to the original
model memory can also be operated in the SAME
transmitter by its copy without establishing the
01:23hR16
bond again.
00:44hR12
Copy fl ight phase
00:33hR08
Select the »Copy fl ight phase« sub-menu with the
00:22hR08
selection keys of the left or right touch pad then
tap on the
SET
Erase model
Copy model –> model
Expor t to SD
Impor t from SD
Copy flight phase
In the "Copy fl ight phase" sub-menu ...
YES
Copy
1
YES
3
5
7
... the fl ight phase to be copied (1 ... 8 for fi xed-wing
models or 1 ... 7 for helicopter models) is selected
with the selection keys of the left or right touch pad
then confi rmed with a brief tap on the
right touch pad. In the next window to appear ...
key.
=>
from phase:
2
4
=>
6
=>
8
SET
key of the
Advertisement
Table of Contents
