Table of Contents
Advertisement
AUXILIARY POWER SUPPLY / BELOW FLOOR OBSTRUCTIONS
Note: The technical informa-
tion provided on pages 72-75 of
this manual is service related.
If you are having an electri-
cal tie-down, power seat or
other auxiliary electrical device
installed in your vehicle, this
information should be supplied
to the technician.
Do not connect
auxiliary devices to
vehicle battery. Doing
so may result in dam-
age to electrical sys-
tem and/or electronic
components.
Page 72
Auxiliary Power Supply: Do not
connect auxiliary devices directly to
the vehicle battery. Doing so may
result in damage to electrical sys-
tem and/or electronic components.
Two fuse blocks are provided as an
auxiliary power source for dealer-in-
stalled auxiliary electrical device(s).
Fuse block details and specifica-
tions are provided on following
page. The fuse blocks are located
at the bottom of the center console.
Below Floor Obstructions:
When installing aftermarket equip-
ment, obstructions below the floor
must be avoided. Obstructions
include HV (high voltage) com-
ponents/wiring, 12V wiring, fuel
system, brake lines, etc. Installers
must be aware of these obstruc-
tions.
Refer to the illustration on page 75
to avoid contacting or damaging
vital components under the floor.
Risk of electrical fire!
Install and electrically
terminate auxiliary
electrical device as
specified by device
manufacturer.
Advertisement
Table of Contents
