Third Row Seats - BraunAbility Side-Entry Power Foldout built on the Hybrid Toyota Sienna Operator's Manual

SEAT REMOVAL AND INSTALLATION
SEAT REMOVAL AND INSTALLATION SEAT REMOVAL AND INSTALLATION SEAT REMOVAL AND INSTALLATION

Third Row Seats

Third row 60/40 split bench seats
have been modified during con-
version procedures. Both seat's
recline and seat back fold flat op-
eration has not be affected. Seat
backs can be folded down to the
flat position. The seat's stow in
floor feature is not available. The
60/40 seats can be removed for
additional cargo space.
Adjusting Tilt or Folding Flat
Third Row Seat Backs
Use front or rear seat strap to
tilt or fold flat the seat backs.
Seats must be returned to the full
deployed (locked) position before
occupying.
Note: Front seat back straps
shown on page 58.
Page 56
Third Row Seat Removal:
60/40 seat removal procedures are the
same. Follow instructions below and
illustrations on the following pages for
seat removal.
1. Deploy footrest (fold down), page 58.
2. If removing 60 seat section, fold seat
head rest and lower center head rest.
3. From the rear of the vehicle, pull seat
back strap and fold down the seat
back.
4. Disconnect seat harness. Each sec-
tion has a harness, harnesses are
located under seat at 60/40 split.
4. Grip the handle on the seat back
and release seat from floor mounted
strikers.
5. Carefully remove seat.
Third Row Seat Installation:
Reverse removal procedures.
Seats backs must
be in upright posi-
tion before occupy-
ing seats. Failure to
do so may result in
serious bodily
injury and/or
property damage.
Install seats as
specified before
occupying seats.
Failure to do so may
result in serious
bodily injury and/or
property damage.