Front Seat Installation - BraunAbility Side-Entry Power Foldout built on the Hybrid Toyota Sienna Operator's Manual

SEAT REMOVAL AND INSTALLATION
SEAT REMOVAL AND INSTALLATION SEAT REMOVAL AND INSTALLATION SEAT REMOVAL AND INSTALLATION
Front Seat Bases (Installation)
Quick-release seat base (riser)
attachments engage recessed
floor strikers. A foot-activated
engagement pedal is located at
the rear of the seat base. Step-
ping on the engagement pedal
engages (locks) the attachments
and retracts the seat base rear
wheels.
Seat attachments
must be fully latched
in floor supports be-
fore occupying seats
or operating vehicle.
Failure to do so will
result in serious
bodily injury.
Page 54
Push seat back downward while
stepping on foot pedal.
Engagement
Pedal
Release
Pedal
Front Seat Installation Instructions
1. Roll seat base into position, just
behind the floor mounted strikers.
See Figures A and B. Move seat
base forward to engage front
strikers. See Figures C and D.
Note: Position outside of seat
base alongside wall panel for
easy alignment.
2. Depress rear engagement pedal
(push down) to stow rear wheels
and engage rear seat attach-
ments with floor strikers. See
Figures C-F. Lift seat to ensure
floor strikers are locked in seat
attachments.
3. Connect (plug) seat electrical
harness to B-pillar receptacle.
See page 50.