Front Seat Removal - BraunAbility Side-Entry Power Foldout built on the Hybrid Toyota Sienna Operator's Manual

SEAT REMOVAL AND INSTALLATION
SEAT REMOVAL AND INSTALLATION SEAT REMOVAL AND INSTALLATION SEAT REMOVAL AND INSTALLATION
Front Seat Bases (Removal)
Quick-release seat base (riser)
attachments engage recessed
floor strikers. A foot-activated
release pedal is located at the
rear of the seat base. Stepping
on the release pedal disengag-
es the attachments and deploys
the seat base rear wheels.
Note: For ease of disengage-
ment, move the seat to the full
forward and upright position
before removing seat(s). Push
the seat back forward and up-
ward while stepping on release
pedal (ensures full deployment
of rear wheels).
Note: Seat harness removed
for clarity.
Page 52
Push seat back forward and upward
while stepping on foot pedal.
Release
Pedal
Front Seat Removal Instructions
1. Move seat to full forward and
upright position.
2. Caution! Disconnect seat wiring
harness before removing a front
seat base. Connect harness to
seat base socket. See pages
49-51 for wiring harness details.
3. Depress release pedal (push
down until it locks). Note: Push
seat back forward and upward
while stepping on release pedal
(shown at left). See Figures
A-D.
4. Pull up and back on the rear of
seat (deploy front wheels). See
Figures E and F.
5. Roll seat base out of vehicle as
shown.