Do you have a question about the Turny HD and is the answer not in the manual?
Questions and answers
Paul Eisen
March 10, 2025
My Turney Evo swivel seat keeps on going into 'Position Lost' mode. Aan you tell me why this might be happening?
1 comments:
Mr. Anderson
March 10, 2025
The BraunAbility Turny HD swivel seat goes into 'Position Lost' mode when the upper stop is not activated, or the maximum position stop when pivoted outward is not engaged. This prevents the seat from being maneuvered. If this occurs, the user should contact their installer for assistance.
Page 1
Turny Seat lift Turny HD Turny Orbit 4 Bruksanvisning 20 User manual 36 Gebrauchsanweisung 52 Instructions d’utilisation 68 Instrucciones de uso 84 Istruzioni per l’uso...
Page 2
If you have any questions about your adaptation, please contact your installation engineer. If you want to know more about us and our range of car adaptation solutions visit www.braunability.eu. Once again, thank you for placing your confidence in our products!
Page 3
Turny Safety Safety measures Operation Hand control Manoeuvring outwards and inwards Emergency-mode operation Raise Turny Orbit/HD Rotate the Turny Orbit inwards Care instructions Troubleshooting Technical specification Introduction for users “Product certificate” at the end of the manual.
Page 5
Turny Getting up Turny can be used as a lifting aid for the user, if at the same a helper carefully moves the seat upwards, see illustration. Transferring to and from wheelchair A transfer between car seat and wheelchair, or vice versa, becomes easier if the transfer is made from a higher to a lower position.
Turny Operation Hand control OUT / In order to rotate outwards and lower Orbit, or lower HD, keep the left-hand but- ton in. To interrupt the movement, release the button. IN / In order to raise and rotate Orbit inwards, or raise HD, keep the right-hand button in.
Page 7
Turny Hand control messages during normal operation. Message Cause No diode lit The vehicle's engine is switched on and/or the door is closed. Turny cannot be manoeuvred. Green LED blinks slowly Energy-saving mode. Green LED lit Rotated inwards to end position. Turny is in a safe position for driving. Green LED blinks Not rotated inwards to end position.
Page 8
Turny Manoeuvring outwards and inwards Rotate outwards Lower Turny Orbit Turny HD Grip the seat. Pull the release lever upwards and Lower the seat to the desired height. rotate the seat outwards to its locked end position.
Page 9
Turny Raise Rotate inwards Turny Orbit Turny HD Grip the seat. Pull the release lever upwards and rotate the seat inwards to its locked end position. When the green LED is constantly lit, Turny is in a safe position for driving.
Page 10
Turny Emergency-mode operation Raise Turny Orbit/HD Option A - easy but slow Take out the crank affixed to the plate behind the back support. Insert the crank behind the hexagonal keyhole at the Turny’ s rear section and fully crank the seat in. 2 cm...
Page 11
Turny Option B - difficult but quick Remove the two cotter pins behind the seat. Lift and then push the chair all the way in. Be firm but careful.
Page 12
Turny Rotate the Turny Orbit inwards Use the yellow release lever at the front of the Turny. Depress and push the lever to the side to release the seat. Push the lever to the right on a right model and to the left on a left model.
Page 13
Turny Rotate the seat fully in. Then move the lever to its original position to lock the seat in position.
Turny Care instructions If necessary ..............Carefully vacuum the Turny. Do not use any liquids. Once a year ..............Contact your installer to book the annual service. Always contact your dealer for disassembly.
Turny Troubleshooting Hand control error messages Message Cause Actions No diode lit The vehicle's engine is switched on and/ Switch off ignition and check that or the door is closed. Power supply fuse(s) and cable(s) are intact. For interrupted. further help contact your installer. 1 Red blink Power surge or pinch protection.
Turny Technical specification From above, rotated out towards the right. The length and width dimen- sions show Turny without covers or accessories. 590 mm 165 mm From the back, rotated out to- 475 mm wards the right. A / Rotation angle Length .....................590 mm HD ......................78°...
Page 17
Turny Introduction for users BraunAbility Europe AB would like you, as a user, to feel secure and comfortable with your new product. For that reason, it is your installer’ s duty to go through the following with you / Safety...
Need help?
Do you have a question about the Turny HD and is the answer not in the manual?
Questions and answers
My Turney Evo swivel seat keeps on going into 'Position Lost' mode. Aan you tell me why this might be happening?
The BraunAbility Turny HD swivel seat goes into 'Position Lost' mode when the upper stop is not activated, or the maximum position stop when pivoted outward is not engaged. This prevents the seat from being maneuvered. If this occurs, the user should contact their installer for assistance.
This answer is automatically generated