Table of Contents
Advertisement
Operation
Menu item
Configuration
Setting
Menu item
Display settings
Reset
PSENscan
Exit
Exit menu in the display.
10.5
Restore configuration
Prerequisites
}
The memory module is installed correctly.
}
The pin assignment must be compatible with the data in the memory module.
One of the following conditions must be met.
}
The MIB files in PSEN sc M and in the memory module are different.
}
The topologies in PSEN sc M and in the memory module are different.
}
The serial numbers saved in PSEN sc M and in the memory module are different.
Procedure:
1. Switch the safety laser scanner on.
When the safety laser scanner is already switched on, switch it off and then on again.
Operating Manual PSEN sc M 3/5 series
1005055-EN-02
Menu second
Meaning
level
Serial number
The serial number of PSEN sc M 3/5 series is dis-
played.
Firmware version
The firmware version of PSEN sc M 3/5 series is
displayed.
Device Lifetime (h)
The current operating time of PSEN sc M 3/5
series in hours is displayed
Configuration-specific displays
Configuration name The name is displayed under which the configura-
tion was saved in PSENscan Configurator.
Check sum
The check sum is displayed that was created when
saving the configuration.
Last saved date
Date of last modification of the project
IP address
The first IP address of the PSEN sc M 3/5 series is
displayed.
MAC address
The MAC address of the PSEN sc M 3/5 series is
displayed.
Menu second
Meaning
level
Rotate
The display is rotated.
Confirming starts a reset of the PSEN sc M 3/5
series.
| 83
Advertisement
Table of Contents
