Testing - Pilz PSEN sc M 3 Series Operating Manual

First commissioning
12. Click on
Specify at least 3 (max. 15) reference points. Specify a max. permitted tolerance for
each reference point. Tol - is the tolerance for the side that faces the safety laser scan-
ner, Tol + is the tolerance for the side that is facing away from the safety laser scanner.
13. In a safety laser scanner arrangement you can configure the detection capability and
the zones for each slave unit separately.
When configuring a safety laser scanner arrangement, configure the detection capabil-
ity and the zones separately for each slave unit.
Select the slave unit(s) you want to configure one after the other and configure the de-
tection capability, the zones and the reference outlines, as required.
9.4

Testing

Before finally commissioning the safety laser scanner after the installation and alignment, fi-
nal inspections must be carried out.
Check safety function of the safety laser scanner
Procedure:
As a test piece, use an opaque object with a height of at least 300 mm and a diameter that
corresponds to the selected detection capability.
Move the test piece at various points along the safety zone into the safety zone:
The OSSDs must switch to the OFF state with each entry of the test piece.
Check ambient conditions and installation
}
Correct alignment and fixing
Check that the fixing screws of the safety laser scanner are firmly seated.
}
Safety distance
The safety distance must comply with the requirements in
distance [
}
Circumventing the safety zone
The danger zone must be safeguarded so that it is impossible to access by circumventing
the safety zone.
}
Safety zone perimeters
The safety zone perimeters (see
guard the danger zone, making it inaccessible.
}
Position of the pushbutton for manual restart
Operating Manual PSEN sc M 3/5 series
1005055-EN-02
.
INFORMATION
This inspection may only be carried out by qualified personnel.
30].
Project configuration [
Maintaining the safety
29]) must completely safe-
| 75