Connecting Dataman 448Pro2Ap-Au To The Pc; Selftest And Calibration Check - Dataman 448PRO2AP-AU User Manual

15. programming module fixating screws
16. rear site type B USB connector for PC  DATAMAN 448PRO2AP-AU communication
cable
17. rear site tie mount for fixating USB cable
18. rear site power supply connector
19. temperature controlled fans
20. "GND" screw can be used for grounding of the programmer

Connecting DATAMAN 448PRO2AP-AU to the PC

Recommendation for connecting programmer to PC:
1. make ground connection between programmer and PC or other ground
2. connect programmer with PC via USB cable
3. connect power supply to programmer.

Selftest and calibration check

If you feel that your programmer does not react according to your expectation, please run the
programmer (ISP connector) selftest using AP1 PMI selftest pod (AP1 ISP connector selftest
pod), enclosed with the standard delivery package.
Selftest of programmer
 Insert AP1 PMI selftest pod into Programmer Module Interface (PMI) connectors of the
programmer.
 Run selftest of programmer in PG4UW (Programmer / Selftest plus).
Rear view to DATAMAN 448PRO2AP-AU
16