User Manual
Step 4 Seal the unused PV terminals with the terminal caps.
- - - - E E n n d d
5.7 WiNet-S Connection
The WiNet-S module supports Ethernet communication and WLAN communication. It is
not recommended to use both communication methods at the same time.
For details, see the quick guide for the WiNet-S module. Scan the following QR code for
the quick guide.
5.7.1 Ethernet Communication
Step 1 ( ( O O p p t t i i o o n n a a l l ) ) Strip the insulation layer of the communication cable with an Ethernet wire
stripper, and lead the corresponding signal cables out. Insert the stripped
communication cable into the RJ45 plug in the correct order, and crimp it with a crimper.
Skip this step if a standard network cable with RJ45 plug is prepared.
Step 2 Unscrew the swivel nut from the communication module and take out the inner sealing
ring.
1: RJ45 plug
5 Electrical Connection
2:Protective cap
31