Moving The Inverter; Installing The Inverter - Sungrow SG2.0RS-S User Manual

User Manual
MC4 terminal
crimping tool (4
mm –6 mm
2

4.4 Moving the Inverter

Before installation, remove the inverter from the packing case and move it to the
installation site. Follow the instructions below as you move the inverter:
• Always be aware of the weight of the inverter.
• Lift the inverter using the handles positioned on both sides of the inverter.
• Move the inverter by one or two people or by using a proper transport tool.
• Do not release the equipment unless it has been firmly secured.

4.5 Installing the Inverter

Inverter is installed on the wall by means of wall-mounting bracket and the expansion
plug sets.
The expansion plug set shown below is recommended for the installation.
(1) Self-tapping
screw M6
Step 1 Place the wall-mounting bracket to a proper position on the wall. Mark the positions and
drill the holes.
Observe the level on the bracket and adjust until the bubble is in the middle
position.
The depth of the holes should be about 70 mm.
Tube terminal
crimping tool (0.5
) mm 2 –1.0 mm
2
(2) Expansion tube
2 )
(3) Fender washer
4 Mechanical Mounting
(4) Spring washer
17