Connecting The Enable Cable; Winet-S Connection; Ethernet Communication - Sungrow SH3.0RS User Manual

User Manual
Refer to the section
terminal on the bottom of the inverter.

6.9.3 Connecting the Enable Cable

The Enable cable along with the RS485 cable, are used for communication between the in-
verter and the Li-ion battery.
For detailed connection description of the RS485 cable, refer to the section
Connection".
For detailed connection description of the Enable cable, refer to the section
nection". Plug the wires into the EN_H and EN_G terminals according the labels on the bot-
tom of the inverter.

6.10 WiNet-S Connection

The WiNet-S module supports Ethernet communication and WLAN communication. It is not
recommended to use both communication methods at the same time.
For details, see the quick guide for the WiNet-S module. Scan the following QR code for the
quick guide.

6.10.1 Ethernet Communication

step 1 (Optional) Strip the insulation layer of the communication cable with an Ethernet wire strip-
per, and lead the corresponding signal cables out. Insert the stripped communication cable
into the RJ45 plug in the correct order, and crimp it with a crimper.
Skip this step if a standard network cable with RJ45 plug is prepared.
"6.13 DRM Connection"
1: RJ45 plug
for details. Plug the wires into the RJ45–CAN
2: Protective cap
6 Electrical Connection
"6.12 RS485
"6.11 Meter Con-
55