Using The Cutting-Unit Kickstand - Toro Reelmaster 5610-D Owner's Manual

1. Lynch pin
2. Lift-arm shaft
6. Insert the lift-arm shaft into the lift arm, and secure
shaft to the arm with the lynch pin and washer.
7. Repeat steps 1 through
unit.
Installing the Cutting Unit Lift-Arm Chains
Secure the lift-arm chain to the chain bracket with the
snapper pin (Figure 31).
Note:
Use the number of chain links described in the
cutting unit Operator's Manual.
1. Lift-arm chain
2. Chain bracket
Installing the Reel Motors
1. Coat the spline shaft of the reel motor with clean
grease.
2. Oil the reel motor O-ring and install it onto the motor
flange.
3. Install the motor by rotating it clockwise so that the
motor flanges clear the bolts
Figure 30
3. Lift arm
4. Washer
6 for the other rear cutting
Figure 31
3. Snapper pin
(Figure 32).
g375239
1. Reel-drive motor
4. Rotate the motor counterclockwise until the flanges
encircle the bolts, and then tighten the bolts.
Important:
are not twisted, kinked, or at risk of being pinched.
5. Torque the mounting bolts to (27 to 33 ft-lb).
4

Using the Cutting-Unit Kickstand

Parts needed for this procedure:
1 Cutting-unit kickstand
g003948
Procedure
Whenever you need to tip the cutting unit to expose the
bedknife/reel, prop up the rear of the cutting unit with the
kickstand to make sure that the nuts on the back end of
the bedbar-adjusting screws are not resting on the work
surface (Figure
18
Figure 32
2. Mounting bolts
Make sure that the reel motor hoses
33).
g004127