Setup; Preparing The Machine - Toro Reelmaster 5610-D Owner's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
Media and Additional Parts
Description
Operator's Manual
Engine operator's manual
Cutting performance paper
Shim
Note:
Determine the left and right sides of the machine from the normal operating position.
1

Preparing the Machine

No Parts Required
Procedure
1. Park the machine on a level surface, lower the cutting
units, and engage the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop.
3. Check the tire air pressure before use; refer to
Checking the Tire Air Pressure (page
Note:
The tires are overinflated for shipping. Adjust
the tire air pressure before operating the machine.
4. Check the hydraulic-fluid level; refer to
Hydraulic-Fluid Level (page
5. Grease the machine; refer to
and Bushings (page
Description
No parts required
No parts required
Right front hose guide
Left front hose guide
Cutting-unit kickstand
Hood lock, seal, and jam nut
Washer
CE decal
Production year decal
Warning decal
66).
Checking the
72).
Greasing the Bearings
54).
Qty.
–
–
1
1
1
1
1
1
1
1
Qty.
1 Read the Operator's Manual before operating the machine.
1 Read the manual before operating the engine.
1 Adjust the cutting-unit bedknife to reel.
1 Adjust the cutting-unit bedknife to reel.
Important:
machine will result in premature failure of critical
parts.
6. Open the hood and check the coolant level; refer to
Checking the Coolant Level (page
7. Check the level of the engine-oil level, and close and
latch the hood; refer to
Engine Oil (page
Note:
The engine ships with oil in the crankcase;
however, check the oil level before and after the
engine is first started.
10
Use
Prepare the machine.
Adjust the control-arm position.
Install the cutting units.
Install the cutting-unit kickstand.
Install the CE hood lock.
Apply the CE decals.
Use
Failure to properly grease the
68).
Checking the Level of the
57).