Positioning the Turf Compensating Spring
and Installing the Hose Guide
Cutting Units 4
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
1.
If the hairpin is installed in the rear hole of the
compensation-spring rod—remove the hairpin and
insert it in the hole next to the bracket
1. Hairpin
2.
Remove the 2 flange locknuts (3/8 inch) and 2
carriage bolts (3/8 x 1-1/4 inches) that secure the
turf-compensator bracket to the cutting-unit frame
(Figure
18).
Figure 6
5. Cutting unit 5
6. Reel motor
7. Weight
(Figure
Figure 7
g375671
1. Carriage bolt (3/8 x 1-1/4
inches)
2. Turf-compensator bracket
3.
Remove the flange locknut (3/8 inch) that secures
the capscrew of the turf compensation spring to
the right tab of the carrier frame, and remove the
compensation spring from the cutting unit
17).
Note:
the capscrew.
1. Capscrew
2. Right tab (Carrier frame)
4.
Assemble the capscrew of the turf compensation
spring to the right tab of the carrier frame
g375689
with the flange locknut (3/8 inch).
12
Figure 8
3. Flange locknut (3/8 inch)
Do not remove the flange serrated nut from
Figure 9
3. Flange locknut (3/8 inch)
g375690
(Figure
19).
g375691
(Figure
20)