Using The Cutting-Unit Kickstand - Toro Reelmaster 5610-D Operator's Manual

Using the Cutting-Unit Kickstand

4
Parts Required
1
1. When tipping a cutting unit to expose the
bedknife/reel, prop up the rear of the cutting
unit with the kickstand
nuts on the back end of the bedbar adjusting
screws are not resting on the work surface.
2. Secure the kickstand
with the snapper pin
3464-493A
Cutting-unit kickstand
to ensure that the
to the chain bracket
.
G402676
G402677
Page 3–12 Setup: Using the Cutting-Unit Kickstand