Toro Reelmaster 5610-D Owner's Manual page 42

Allowing a Reset Regeneration
The InfoCenter displays the high exhaust-temperature icon
when the reset regeneration is in process.
Note:
If I R
NHIBIT EGEN
displays A #185
DVISORY
inhibit regeneration setting to O
reset regeneration.
Note:
If the engine exhaust temperature is too low, the
InfoCenter displays A
DVISORY
you to set the engine to full throttle (high idle).
Note:
When the reset regeneration completes, the
high exhaust-temperature
InfoCenter screen.
is set to O , the InfoCenter
N
(Figure 72). Press button 3 to set
and continue with the
FF
Figure 72
#186 (Figure 73) to inform
Figure 73
disappears from the
Parked or Recovery Regeneration
•
When the engine computer requests either a
parked regeneration or a recovery regeneration, the
regeneration request icon
InfoCenter.
•
The machine does not automatically perform a parked
regeneration or a recovery regeneration, you must run
the regeneration through the InfoCenter.
g224394
Parked Regeneration Messages
When a parked regeneration is requested by the engine
computer the following messages display in the InfoCenter:
•
Engine warning SPN 3720, FMI 16
g224395
•
Parked regeneration required A
76)
Note:
Advisory #188 displays every 15 minutes.
•
If you do not perform a parked regeneration within 2
hours, the InfoCenter displays parked regeneration
required—power takeoff disabled A
(Figure 77).
42
(Figure 74) displays in the
Figure 74
(Figure 75)
Figure 75
#188
DVISORY
Figure 76
#189
DVISORY
g224404
g213863
(Figure
g224397