Toro Reelmaster 5610-D Owner's Manual page 27

If you changed the PIN code and forgot the code, contact
your authorized Toro distributor for assistance.
1. From the M M
AIN ENU
down to the S
ETTINGS
(Figure 47).
2. In the S M
ETTINGS ENU
down to the P
ROTECTED
button (Figure 48A).
3. To enter the PIN code, press the center button until
the correct first digit appears, then press the right
button to move on to the next digit
Figure 48C). Repeat this step until the last digit is
entered and press the right button once more.
4. Press the middle button to enter the PIN code
48D).
Wait until the red indicator light of the InfoCenter
illuminates.
Note:
If the InfoCenter accepts the PIN code and
the protected menu is unlocked, the word "PIN"
displays in the upper right corner of the screen.
, use the center button to scroll
M and press the right button
ENU
Figure 47
, use the center button to scroll
M and press the right
ENU
Figure 48
(Figure 48B and
Note:
Rotate the key switch to the O
to the O position locks the protected menu.
N
You can view and change the settings in the Protected
Menu. Once you access the Protected Menu, scroll down
to Protect Settings option. Use the right button to change
the setting. Setting the Protect Settings to O
to view and change the settings in the Protected Menu
without entering the PIN code. Setting the Protect Settings
to O hides the protected options and requires you to enter
N
the PIN code to change the setting in the Protected Menu.
After you set the PIN code, rotate the key switch O
back to the O
Setting the Auto Idle
1. In the Settings Menu, scroll down to Auto Idle.
g028523
2. Press the right button to change the auto idle time
between O
Setting the Blade Count
1. In the Settings Menu, scroll down to Blade Count.
2. Press the right button to change the blade count
between 5, 8, or 11 blade reels.
Setting the Mow Speed
1. In the Settings Menu, scroll down to Mow Speed.
2. Press the right button to select mow speed.
3. Use the center and right button to select the
appropriate mow speed set on the mechanical
mow-speed limiter on the traction pedal.
4. Press the left button to exit mow speed and save the
setting.
Setting the Height of Cut (HOC)
1. In the Settings Menu, scroll down to HOC.
2. Press the right button to select HOC.
3. Use the center and right button to select the
appropriate HOC setting. (If the exact setting is not
displayed, select the nearest HOC setting from the
list displayed).
4. Press the left button to exit HOC and save the setting.
g028522
Setting the Front and Rear Reel Speeds
Although the front and rear reel speeds are calculated by
inputting the number of blades, mow speed and HOC into
the InfoCenter, the setting can be manually changed to
accommodate for different mowing conditions.
1. To change the Reel Speed Settings, scroll down to
(Figure
the F Reel RPM, R Reel RPM, or both.
2. Press the right button to change the reel speed
value. As you change the speed setting, the display
continues to show the calculated reel speed based
on blade count, mow speed and HOC, which
was previously entered, but the new value is also
displayed.
27
position to enable and save this feature.
N
, 8S, 10S, 15S, 20S, and 30S.
FF
position and then
FF
allows you
FF
and
FF