Toro Reelmaster 5610-D Owner's Manual page 26

Hours
Counts
DPF Regeneration
Inhibit Regen
Parked Regen
Last Regen
Recover Regen
Counts
Diagnostics
Menu Item
Cutting Units
Hi/Low Range
PTO
Engine Run
Backlap
Settings
Menu Item
Units
Language
LCD Backlight
LCD Contrast
Front Backlap Reel Speed
Lists the total number of hours
that the machine, engine and
PTO have been on, as well
as the number of hours the
machine has been transported
and service due
Lists the number of starts,
cutting unit/PTO cycles, and
fan reversals the machine has
experienced
The diesel particulate filter
regeneration option and DPF
submenus
Use to control reset
regeneration
Use to initiate a parked
regeneration
Lists the number hours since
the last reset, parked, or
recovery regeneration
Use to initiate a recovery
regeneration
Lists numerous counts the
machine has experienced
Description
Indicates the inputs, qualifiers
and outputs for raising and
lowering the cutting units.
Indicates the inputs, qualifiers
and outputs for driving in
transport mode.
Indicates the inputs, qualifiers
and outputs for enabling the
PTO circuit.
Indicates the inputs, qualifiers
and outputs for starting the
engine.
Indicates the inputs, qualifiers
and outputs for operating the
backlap function.
Description
Controls the units used on the
InfoCenter. The menu choices
are English or metric.
Controls the language used
on the InfoCenter*.
Controls the brightness of the
LCD display.
Controls the contrast of the
LCD display.
Controls the speed of the front
reels in backlap mode.
Rear Backlap Reel Speed
Protected Menus
Auto Idle
Blade Count
Mow Speed
Height of cut (HOC)
F Reel RPM
R Reel RPM
*Only operator-faced text is translated. Faults, Service, and
Diagnostics screens are service-faced. Titles appear in the
selected language, but menu items are in English.
Protected under Protected Menus—accessible only by
entering PIN
About
Menu Item
Model
SN
Machine-Controller Revision
InfoCenter Revision
CAN Bus
Protected Menus
There are 8 operating configuration settings that are
adjustable within the Settings Menu of the InfoCenter: auto
idle time delay, Blade Count, Mow Speed, Height of Cut
(HOC), F Reel RPM, and R Reel RPM. These settings can
be locked by using the Protected Menu.
Note:
At the time of delivery, the initial password code is
programmed by your distributor.
Accessing Protected Menus
Note:
The factory default PIN code for you machine is
either 0000 or 1234.
26
Controls the speed of the rear
reels in backlap mode.
Allows a person authorized
by your company with the
PIN code to access protected
menus.
Controls the amount of time
allowed before returning the
engine to low idle when the
machine is stationary.
Controls the number of blades
on the reel for reel speed.
Controls the ground speed for
determining the reel speed.
Controls the height of cut
(HOC) for determining the reel
speed.
Displays the calculated reel
speed position for the front
reels. The reels can also be
manually adjusted.
Displays the calculated reel
speed position for the rear
reels. The reels can also be
manually adjusted.
Description
Lists the model number of the
machine.
Lists the serial number of the
machine.
Lists the software revision of
the master controller.
Lists the software revision of
the InfoCenter.
Lists the machine
communication bus status.