Toro Reelmaster 5610-D Owner's Manual page 16

1. Chain bracket
2. Snapper pin
Installing the Front Cutting Units to the Lift
Arms
1. Slide a cutting unit under the lift arm
1. Cap
2. Snapper pin
2. Assemble the lift-arm yoke onto the carrier frame
shaft.
3. Assemble the cap to the pivot-arm shaft, and align
the holes in the carrier frame shaft, pivot arm shaft,
and cap.
4. Secure the cap and the carrier-frame shaft to the
lift-arm yoke with the snapper pin.
Locking the Cutting-Unit Pivot for Cutting Grass
on a Hill Side—Lock the cutting-unit pivots to prevent
the cutting units from rotating downhill when cutting
Figure 22
3. Cutting-unit kickstand
(Figure
Figure 23
3. Lift-arm yoke
4. Carrier frame shaft
across the face of a hill. Use the hole in the lift-arm
pivot shaft
slot for a steering cutting unit.
g004144
1. Snap-pin positions
2. Hole (lift-arm pivot shaft)
Installing the Rear Cutting Units to the Lift
Arms
Cutting Units adjusted for a 1.2 cm (3/4 inch) or Higher
Height of Cut
23).
1. Slide a cutting unit under the lift arm
g375274
1. Cap
2. Snapper pin
2. Assemble the lift-arm yoke onto the carrier frame
shaft.
3. Assemble the cap to the pivot-arm shaft, and align
the holes in the carrier frame shaft, pivot arm shaft,
and cap.
16
(Figure 24) to lock the cutting unit. Use the
Figure 24
3. Slot (lift-arm pivot shaft)
Figure 25
3. Lift-arm yoke
4. Carrier frame shaft
g375251
(Figure 25).
g375252