Toro Reelmaster 5610-D Owner's Manual page 13

Figure 10
1. Flange locknut (3/8 inch)
2. Right tab (Carrier frame)
5. Align the studs of the left hose guide with the holes
in the cutting-unit frame and the turf-compensator
bracket (Figure 21).
Note:
The support loop of the hose guide aligns
toward the centerline of the machine.
Figure 11
1. Turf-compensator bracket
2. Flange locknut (3/8 inch)
6. Assemble the hose guide and turf-compensator
bracket to the cutting-unit frame with the 2 flange
locknuts (3/8 inch).
7. Torque the locknuts and bolts to 37 to 45 N∙m (27 to
33 ft-lb).
g375694
3. Capscrew
g375687
3. Stud (hose guide)
4. Inboard
Installing the Hose Guide
Cutting Units 5
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
1. If the hairpin is installed in the rear hole of the
compensation-spring rod—remove the hairpin and
insert it in the hole next to the bracket
1. Hairpin
2. Remove the 2 flange locknuts (3/8 inch) and 2
carriage bolts (3/8 x 1-1/4 inches) that secure the
turf-compensator bracket to the cutting-unit frame
(Figure 14).
13
Figure 12
5. Cutting unit 5
6. Reel motor
7. Weight
(Figure
Figure 13
g375672
12).
g375689