Toro Reelmaster 5610-D Owner's Manual page 22

1. Traction pedal
2. Mow/transport lever
3. Mow-speed limiter and
spacers
Mow/Transport Lever
Use the mow/transport lever
into M mode or T
OW RANSPORT
forward to select the M
OW
the T mode.
RANSPORT
Note:
The cutting units cannot be lowered when the
mow/transport lever is in the T
Mow-Speed Limiter
When the mow-speed limiter
up/forward it limits the mow speed and allow the cutting
units to be engaged. Each spacer adjusts the mowing
speed by 0.8 km/h (0.5 mph). The more spacers there are
on the top of the bolt, the slower the machine goes. Flip the
mow speed limiter backward to allow maximum transport
speed.
Brake Pedal
Press the brake pedal to stop the machine
Parking Brake
To engage the parking brake, push down on the brake
pedal and press the top forward to latch
release the parking brake, press the brake pedal until the
parking-brake latch retracts.
Tilt-Steering Pedal
To tilt the steering wheel towards you, press the foot pedal
(Figure 41) down, pull the steering tower toward you to the
most comfortable position, and release the pedal.
Figure 41
4. Brake pedal
5. Parking brake
6. Tilt steering pedal
(Figure 41) to put the machine
mode. Push the lever
mode, and backward to select
position.
RANSPORT
(Figure 41) is flipped
(Figure
(Figure
Engine-Speed Switch
The engine-speed switch has 2 modes to change the
engine speed
switch, you can change the engine speed in 100 rpm
increments. If you hold the switch down, the engine
automatically moves to High or Low idle, depending on
which end of the switch you press.
g003955
1. Lower mow/raise control
lever
2. Key switch
3. InfoCenter
Lower Mow/Raise Control Lever
This lever
and you use the lever to start and stop the cutting units
when the mow/transport lever is in the M
enable/disable switch is in the E
lower the cutting units when the mow/transport lever is in
the T
RANSPORT
Key Switch
The key switch
O /P
N REHEAT
InfoCenter
The InfoCenter LCD display shows information about your
machine, such as the operating status, various diagnostics,
and other information about the machine
41).
Enable/Disable Switch
Use the enable/disable switch
with the lower mow/raise control lever to operate the cutting
41). To
units.
Headlight Switch
Pivot the switch downward to turn on the headlights
42).
22
(Figure 42). By momentarily tapping the
Figure 42
4. Enable/disable switch
5. Engine-speed switch
6. Headlight switch
(Figure 42) raises and lowers the cutting units,
NABLE
position.
(Figure 42) has 3 positions: O
, and S .
TART
(Figure
g021208
mode and the
OW
position. You cannot
,
FF
(Figure 42).
42) in conjunction
(Figure