Chassis Maintenance; Inspecting The Seat Belt - Toro Reelmaster 5610-D Owner's Manual

Important:
Never use a short-handled brush.
4. If the reels stall or become erratic while backlapping,
select a higher reel-speed setting until the speed
stabilizes, then return the reel speed to your desired
speed.
5. If you need to make an adjustment to the cutting units
while backlapping, perform the following steps:
A. Moving the Lower Mow/Raise lever rearward
and press the Enable/Disable switch to D
position.
B. Shut off the engine and remove the key.
C. Adjust to the cutting units.
D. Repeat steps
6. Repeat steps 3 for the other cutting units that you
want to backlap.
Finishing Backlapping
1. Moving the Lower Mow/Raise lever rearward and
press the Enable/Disable switch to D
2. Shut off the engine and remove the key.
3. Move the backlap levers to the F (mow) position
(Figure 153).
Important:
If you do not change backlap lever
to the F (mow) position after backlapping, the
cutting units will not function properly.
Figure 153
4. Lower and latch the operator's seat; refer to
the Seat (page 53).
5. Wash all lapping compound off from the cutting units.
6. For a better cutting edge, run a file across the front
face of the bedknife after lapping.
Note:
This removes any burrs or rough edges that
may have built up on the cutting edge.
1 through 3.
ISABLE

Chassis Maintenance

Inspecting the Seat Belt

Service Interval: Before each use or daily
1. Inspect the seat belt for wear, cuts, and other damage.
Replace the seat belt(s) if any component does not
operate properly.
ISABLE
2. Clean the seat belt as necessary.
position.
g377117
Lowering
76