Toro Reelmaster 5610-D Owner's Manual page 41

Reset Regeneration
CAUTION
The exhaust temperature is hot (approximately 600°C
(1,112°F) during DPF regeneration. Hot exhaust gas
can harm you or other people.
•
Never operate the engine in an enclosed area.
•
Make sure that there are no flammable materials
around the exhaust system.
•
Never touch a hot exhaust system component.
•
Never stand near or around the exhaust pipe of the
machine.
•
The high exhaust-temperature icon
the InfoCenter (Figure
•
The engine computer adjusts engine settings to raise
the exhaust temperature.
Important:
The high exhaust-temperature icon
indicates that the exhaust temperature discharged
from of your machine may be hotter than during
regular operation.
•
While operating the machine, run the engine at full
engine speed and high load when possible to promote
DPF regeneration.
•
The icon displays in the InfoCenter while the reset
regeneration is processing.
•
Whenever possible, do not shut off the engine or
reduce engine speed while the reset regeneration is
processing.
Important:
Whenever possible, allow the machine
to complete the reset regeneration process before
shutting off the engine.
Periodic Reset Regeneration
If the engine has not completed a successful Reset,
Parked, or Recovery regeneration in the previous 100
hours of engine operation, the engine computer will attempt
to perform a reset regeneration.
Figure 68
displays in
68).
Setting the Inhibit Regen
Reset Regeneration Only
Note:
If you set the InfoCenter to inhibit regeneration, the
InfoCenter displays A
minutes while the engine requests a reset regeneration.
A reset regeneration produces the elevated engine exhaust.
If you are operating the machine around trees, brush, tall
grass, or other temperature-sensitive plants or materials,
you can use the Inhibit Regen setting to prevent the engine
computer from performing a reset regeneration.
Important:
When you shut off the engine and start it
again, the inhibit regen setting defaults to O
1. Access the DPF Regeneration menu, press the center
button to scroll down to the I
press the right button to select the Inhibit Regen entry
(Figure 70).
g224417
2. Press the right button to change the inhibit
regeneration setting from On to Off
from Off to On
41
#185 (Figure 69) every 15
DVISORY
Figure 69
R
NHIBIT EGEN
Figure 70
(Figure
(Figure 71).
Figure 71
g224692
.
FF
option, and
g227304
70) or
g224691