Using The Cutting-Unit Kickstand; Installing The 48 V Disconnect Jumper And Closing The Seat Base - Toro Reelmaster 5010-H Operator's Manual

5
Using the Cutting-Unit
Kickstand
Parts needed for this procedure:
1 Cutting-unit kickstand
Procedure
Whenever you need to tip the cutting unit to expose
the bedknife/reel, prop up the rear of the cutting unit
with the kickstand to make sure that the nuts on the
back end of the bedbar-adjusting screws are not
resting on the work surface
Figure 29
1. Cutting-unit kickstand
Secure the kickstand to the chain bracket with the
snapper pin (Figure 30).
(Figure 29).
g003985
1. Chain bracket
2. Snapper pin
6
Installing the 48 V
Disconnect Jumper and
Closing the Seat Base
No Parts Required
Procedure
1. Apply dielectric grease to the contact surfaces
of the battery disconnect jumper
19
Figure 30
3. Cutting-unit kickstand
(Figure
g004144
31).