Toro Reelmaster 5610-D Owner's Manual page 25

Start the engine.
Shut off the engine.
Engine
Key switch
The cutting units are lowering.
The cutting units are raising.
PIN code
CAN bus
InfoCenter
Bad or failed
Bulb
Output of TEC controller or control
wire in harness
Switch
Release the switch.
Change to the indicated state.
Symbols are often
combined to form
sentences. Some
examples are shown
below
Put the machine into Neutral.
Engine start is denied.
Engine shutdown
Engine coolant is too hot.
DPF ash-accumulation
notification—Refer to
Accumulation (page 37)
Reset-standby regeneration request
Parked or recovery regeneration
request
Accessible only by entering PIN
Using the Menus
To access the InfoCenter menu system, press the menu
access button while at the main screen. This brings you to
the main menu. Refer to the following tables for a synopsis
of the options available from the menus:
Main Menu
Menu Item
Faults
Service
Diagnostics
Settings
DPF Ash
About
for details.
Service
Menu Item
25
A parked or recovery regeneration is
processing.
High exhaust temperature
NOx control diagnosis malfunction;
drive the machine back to the shop
and contact your authorized Toro
distributor (software version U and
later).
The power take-off is disabled.
Sit down or engage the parking
brake.
Description
Contains a list of the recent
machine faults. Refer to the
Service Manual or contact your
authorized Toro distributor for
more information on the Faults
menu and the information
contained there.
Contains information on the
machine such as hours of
use counters and other similar
numbers.
Displays the state of each
machine switch, sensor and
control output. You can use
this to troubleshoot certain
issues as it quickly tells you
which machine controls are on
and which are off.
Allows you to customize and
modify configuration variables
on the InfoCenter display
Lists the model number, serial
number, and software version
of your machine
Description