Replacing The Water-Separator Filter; Replacing The Engine Fuel Filter; Checking The Fuel Lines And Connections; Cleaning The Fuel-Pickup Tube Screen - Toro Reelmaster 5610-D Owner's Manual

6. Start the engine and check for leaks.
Note:
Repair all leaks.
7. Shut off the engine and remove the key.
8. Close and latch the hood;

Replacing the Water-Separator Filter

Service Interval: Every 400 hours
1. Fully drain the fuel-water separator; refer to
Water from the Fuel-Water Separator (page
2. Clean the filter head and filter canister
Figure 120
1. Filter head
3. Remove the filter canister, and clean the mounting
surface of the filter head.
4. Lubricate the gasket on the filter canister with clean
fuel.
5. Install the filter canister by hand until the gasket
contacts the mounting surface, then rotate it an
additional 1/2 turn.
6. Tighten the drain valve at the bottom of the filter
canister.
7. Start the engine and check for leaks.
Note:
Repair all leaks.
8. Shut off the engine and remove the key.
9. Close and latch the hood;

Replacing the Engine Fuel Filter

Service Interval: Every 400 hours—Replace the engine
fuel filter.
1. Open the hood; refer to
2. Clean the area around the fuel-filter head
121).
Closing the Hood (page
Draining
59).
(Figure 120).
2. Filter canister
Closing the Hood (page
Opening the Hood (page
(Figure
52).
1. Fuel-filter head
3. Remove the filter, and clean the filter-head mounting
surface (Figure
4. Lubricate the filter gasket with clean lubricating
engine oil.
5. Install the dry filter canister, by hand, until the gasket
contacts the filter head, then rotate it an additional
1/2 turn.
6. Start the engine and check for fuel leaks around the
filter and filter head.
g378080
Repair all fuel leaks.
7. Shut off the engine and remove the key.
8. Close and latch the hood; refer to
(page 52).
Checking the Fuel Lines and
Connections
Service Interval: Every 400 hours (or yearly, whichever
Check the fuel lines and connections for deterioration,
damage, or loose connections.

Cleaning the Fuel-Pickup Tube Screen

Removing the Fuel-Pickup Tube
52).
The fuel-pickup tube, located inside the fuel tank, comes
with a screen to help prevent debris from entering the fuel
system. Remove the fuel-pickup tube and clean the screen
as required.
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
52).
2. Remove the 5 Phillips-head screws that secure the
fuel-sender cover to the fuel tank, and remove the
cover (Figure
60
Figure 121
2. Fuel filter
121).
Closing the Hood
comes first).
52).
122).
g378468