Canon CR-1 MARK II Operation Manual page 2

PLEASE NOTE
1. For 110/120V countries:
Computer and monitor used in the retinal imaging control software NM must be conforming to the
IEC60601-1/UL60601-1 or IEC60950/UL60950. Be sure to also use an isolation transformer conforming to
IEC60601-1/UL60601-1 when a computer or monitor conforming to IEC60950/UL60950 is used.
For 220/230/240V countries:
Computer and monitor used in the retinal imaging control software NM must be conforming to the
IEC60601-1/UL60601-1.
2. Reading of image and storage of data must be performed in accordance with the law of the country where
the product is being used. Also, the user is responsible for maintaining the privacy of image data.
3. In no event will Canon be liable for direct or indirect consequential damage arising out of the use of this
product.
Canon will not be liable for loss of image data due to any reason.
4. Before installing this product, you must read through the license agreement covering the terms and
conditions under which the software is to be used.
5. Please ask the distributor or Canon representative where you made the purchase to install this product.
6. Canon reserves the right to change the specifications and other aspects of this product without prior notice.
• Microsoft and Windows are either registered trademarks or trademarks of Microsoft Corporation in the
United States and/or other countries.
• Other systems and product names in this manual are the trademarks of each manufacturer that developed
them.
© CANON INC. 2009
All rights reserved.
Under copyright laws, this manual may not be copied, in whole or in part, without the written consent
of Canon.