Canon CR-1 MARK II Operation Manual page 132

8. Before calling the service technician (Warning)
module id message id
10050
10053
10063
10065
Character '\' or control character cannot be used for
18
Patient ID.
A character/characters for Patient ID is/are not
19 supported by Acceptable Character Set or Specific
Character Set.
Header String for Accession No. exceeds the
20
maximum length.
Character '\' or control character cannot be used for
21
Accession No..
A character/characters for Accession No. is/are not
22 supported by Acceptable Character Set or Specific
Character Set.
Header String for Study Description exceeds the
23
maximum length.
Character '\' or control character cannot be used for
24
Study Description.
A character/characters for Study Description is/are
25 not supported by Acceptable Character Set or
Specific Character Set.
26 Patient/Study Info. Setting Error
Reset the maximum Length and Header string for
29 Accession No. so that Counter value will be two
digits or more.
This type of a magnetic card/bar code reader
1000
cannot use Connection Check function.
Enter essential data.
1001
[item]
Enter in numeric.
1002
[item]
Entered value exceeds the limit.
1003
[item (*** - ***)]
1004 Entered value could not be checked.
Entered value is not numeric or out of range.
1005
[item]
4097 C/D Ratio data will be updated.
Message
-124-
Detail
Delete the backslash (\) and any control characters.
Input using the designated input character type or
specific character set.
Set the length of the Header string within the length
limitation.
Delete the backslash (\) and any control characters.
Enter using the designated input character type or
specific character set.
Set the length of the Header string within the length
limitation.
Delete the backslash (\) and any control characters.
Enter using the designated input character type or
specific character set.
Set again the Patient/Study Info. based on the
information displayed in [Details].
Refer to the message details, and set the Accession
No.
Check the magnetic card/barcode reader settings.
Input the required item that is displayed.
Input the displayed item in single-byte alphanumeric
characters.
Input the displayed item within the limitation.
Check the input value in the JPEG Settings
screen (see page 70), and set it again if necessary.
Enter a value within the correct range for the
displayed item.
Click [OK] to overwrite the C/D ratio data.
To cancel overwriting, click [Cancel].