Canon CR-1 MARK II Operation Manual page 125

Retinal imaging control software nm
Hide thumbs Also See for CR-1 MARK II:
Table of Contents

Advertisement

module id message id
Required fields must be entered.
25
[item]
The path for storage directory exceeds the
26
maximum length.
[Max. *** bytes]
27
Storage directory does not exist.
Drive specified for storage directory (folder) is not
28
10004
a fixed disk.
Insufficient Free Space in Storage Directory
30
[** GB]
43
Character ' ' cannot be used.
4105
Failed to read the external study.
Over Discharge
103
Do not operate the retinal camera for a while.
EOS Digital camera is not mounted.
104
Mount the camera or select Sub Camera mode.
107
Communication Port Error
108
Communication Protocol Error
Photography frequency exceeded the limit.
109
Please wait.
10005
201
Mirror Drive Error in EOS Camera Mode
202
X-contact Error in EOS Camera Mode
204
Retinal camera was operated in Idle mode.
205
Flash Not Fired
206
X-contact Error in EOS Camera Mode
1000
Default QA parameters by mode will be changed.
1001
Selected QA parameter set will be deleted.
10006
Current QA parameter values will be applied to all
1002
the selected images.
1003
Selected QA parameter set will be updated.
Invalid Image Comments
1000
A character/characters for Image Comments is/are
not supported by Specific Character Set.
10009
Invalid Image Comments
1001
A character/characters for Image Comments is/are
not supported by Specific Character Set.
A character/characters for User Name is/are not
10010
8
supported by Specific Character Set.
Change the user name.
8. Before calling the service technician (Warning)
Message
-117-
Detail
Input the required items.
The titles of the required items are indicated in blue.
Select a folder where the path for the Image Storage
Directory (Folder) (see page 80) is fewer than 150
bytes.
Check that the storage directory (see page 80)
which has been set actually exists.
Set the storage directory (see page 80) on the fixed
disk.
Increase the amount of free memory on the fixed
disk on which the storage directory has been set
(see page 80).
Do not input spaces for the tags and separators of the
Image Comment Settings screen (see page 98).
Upgrage the version of the Retinal imaging control
software NM (CR-1 Mark II) to the same version as
that you used to save the file, or to a newer version.
Wait for a few moments, and then take the images.
Mount the digital camera on the retinal camera.
Turn the retinal camera's power off and back on.
Turn the computer's power off and back on.
Images cannot be saved since images were taken
continuously over a short period of time.
Wait for a few moments, and then take the images.
Turn the equipment's power off and back on, and
take a test image.
Do not press the shutter release button of the retinal
camera while the photography ready lamp is not
lighted up green.
Turn the equipment's power off and back on, and
take a test image.
To return the current settings to the default values,
click [OK] on the QA (Quality Assurance) screen
(see page 65).
To delete the current QA parameter set to the default
value, click [OK] on the QA (Quality Assurance)
screen (see page 65).
To apply the current settings to all the selected
images, click [OK] on the QA (Quality Assurance)
screen (see page 65).
To overwrite the QA parameter set with the current
settings, click [OK] on the QA (Quality Assurance)
screen (see page 65).
Delete any control characters.
Input using the specific character set.
Input the user name using the specific character set.
Continued on the following page >>

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents