Table of Contents
Advertisement
6.2
Input to the inverter through the network
Main commands which can be input from the master to the inverter and their descriptions are explained below.
Item
Forward rotation command
Reverse rotation command
Input terminal function command
Inverter output stop command
Error reset
Frequency setting
Torque command / torque limit
Monitor command
Operation mode specification
Fault history clear
All parameter clear
Inverter reset
Parameter write
PID control
The setting is available only for the FR-A800 series.
Give the forward rotation command.
Give the reverse rotation command.
Execute functions assigned to the inverter input terminals.
Stop the inverter output.
Reset the inverter only when an inverter alarm occurs.
Set the frequency.
Set the torque command or the torque limit.
Specify the description monitored.
Set the operation mode.
Erase past eight fault records.
Return the parameter descriptions to the initial value.
Reset the inverter.
Write parameter settings.
PID set point, PID measured value and PID deviation can be input
from the network.
Description
FUNCTION OVERVIEW
Refer to page
70
70
70
70
71
74,
80
74,
84
78,
79
79
81
81
81
81
6
74
57
Advertisement
Table of Contents
