SIS Overview
Using the Command and Response Table
The
the commands that the PowerCage 401 enclosure recognizes as valid, the responses that
are returned to the host, a description of the command function or the results of executing
the command, and examples of commands in ASCII.
NOTE: Uppercase and lowercase text can be used interchangeably unless otherwise
Space
Figure 16.
Verbose Mode
The connection to a PowerCage 401 can be used to monitor for changes that occur on
the switcher, such as front panel operations and SIS commands from a TCP/IP connection
or the RS-232 serial port. To receive change notices from the PowerCage 401, you must
enable verbose mode 1 or 3 (see
3, changes are reported in messages that resemble SIS command responses.
Symbol Definitions
]
}
•
|
E
Command and Response Tables for SIS Commands
stated.
ASCII to Hex Conversion Table
ASCII to Hexadecimal Conversion
= CR/LF Carriage return with line feed
= Carriage return with no line feed (for URL-encoded commands, use the pipe
character, | , instead)
= Space character
= Pipe (vertical bar) character
=
Escape key (for URL-encoded commands, use W instead)
PowerCage 401 Enclosure • SIS Configuration and Control
•
Set verbose mode
on page 28). In verbose mode 1 or
starting on page 25 lists
24