Extron electronics PowerCage 401 User Manual page 39

Command
Resets
Erase all files from flash
memory
Reset unit settings
Absolute system reset,
but retain IP
Absolute system reset
IP system reset
NOTE: The factory configured passwords for all accounts on this enclosure have been set to the enclosure serial
number. In the event of a complete system reset, the passwords convert to the default, which is no password (see
Password and security settings
Reboot system
Reboot system
Restart network
NOTE: Changes made to IP Address, Subnet Mask, DHCP, and/or Gateway Address do not take effect until the 2BOOT
command is issued, except for changes made via the CISG command (which takes place immediately and does not
require rebooting).
ASCII Command Response
(host to PowerCage) (PowerCage to host)
E }
ZFFF Zpf
E }
ZXXX Zpx
E }
ZY Zpy
E }
ZQQQ Zpq
E 1ZQQQ } Zpq1 ]
on page 27 to change a password).
E }
1 BOOT Boot 1
E }
2 BOOT Boot 2
PowerCage 401 Enclosure • SIS Configuration and Control
]
]
]
]
]
]
Additional Description
Removes files created in
user space.
Resets unit back to factory
default.
This reset is the same as
ZQQQ except excludes IP
setting.
Master reset, resets IP
address and subnet mask
to default. Also resets all
installed boards.
Resets only IP settings.
31