Table of Contents
Advertisement
1
Performance Verification Tests
3 On the U1610/20A:
a Press
b Press
c Press
d Press
4 On the calibrator, perform the following configuration:
– Output: Level sine
– OPR/STBY: OPR
– Frequency: 1 MHz
– Amplitude: 1.2 V
5 On the U1610/20A:
a Press
b Press
c Wait a few seconds for the measurement to settle. View the RMS reading at
6 On the calibrator, change the frequency to 100 MHz (for U1610A) or 200 MHz
(for U1620A).
24
All manuals and user guides at all-guides.com
to set the horizontal scale factor to 200 ns/div.
to set the vertical sensitivity for channel 1 to 500 mV/div.
>
>
trigger source.
>
(F2) and use the
measurement, and then press
the bottom of the display.
Record the reading: VRMS = _______ V
(F1) to set the acquisition mode to Normal.
>
(F2) to select the channel 1
(F1) to select the channel 1 source.
keys to select the RMS (AC)
(F3).
Keysight U1610/20A Service Guide
Advertisement
Table of Contents
