Table of Contents
Advertisement
Install the drive.
3.
Removing a hot-plug SAS or SATA drive
CAUTION:
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
Determine the status of the drive from the hot-plug SAS drive LED combinations
1.
definitions" on page 18).
Back up all server data on the drive.
2.
Remove the drive.
3.
2 SFF SAS/SATA drive cage assembly option
WARNING:
internal system components to cool before touching them.
CAUTION:
beginning any installation procedure. Improper grounding can cause ESD.
Back up all server data.
1.
Power down the server (on page 20).
2.
Do one of the following:
3.
Extend the server from the rack (on page 20).
o
Remove the server from the rack (on page 21).
o
For proper cooling, do not operate the server without the access panel, baffles,
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To prevent damage to electrical components, properly ground the server before
("Hot-plug drive LED
Hardware options installation 45
Hide quick links:
Advertisement
Table of Contents
