Table of Contents
Advertisement
Buttons
: Click to reset the configuration to Factory Defaults.
: Click to return to the Port State page without resetting the configuration.
To reset the Industrial Managed Switch to the Factory default setting, you can also press the hardware
reset button at the front panel about 10 seconds. After the device be rebooted. You can login the
management WEB interface within the same subnet of 192.168.0.xx.
4.2.27 System Reboot
The Reboot page enables the device to be rebooted from a remote location. Once the Reboot button is pressed, users have to
re-login the Web interface for about 60 seconds later as the System Reboot screen in
Buttons
: Click to reboot the system.
: Click to return to the Port State page without rebooting the system.
You can also check the SYS LED on the front panel to identify whether the System is loaded completely or
not. If the SYS LED is blinking, then it is in the firmware load stage; if the SYS LED light is on, you can use
the Web browser to login the Industrial Managed Switch.
Figure 4-2-31: System Reboot page Screenshot
105
User's Manual
Figure 4-2-31
appears.
Advertisement
Table of Contents
