Installing The Hard Drive - FLIR Digimerge D33084T Instruction Manual

• If your system has a 2.5" hard drive, turn the DVR over carefully. Hold the hard drive in place
and remove the 4 screws securing the hard drive. Keep holding the hard drive and turn the
DVR back over. Remove the hard drive from the DVR.
5 Replace the DVR cover.

Installing the Hard Drive

Make sure that the power cable has been disconnected before changing the
hard drive.
1 Remove the screws from each side panel (x2) and rear panel (x4) of the cover.
2 Gently slide the cover away from the rear panel and lift off. Be careful of sharp edges.
3 Next, install the hard drive:
• If installing a 3.5" hard drive, remove the 4 screws holding the hard drive bracket and remove
the bracket from the DVR. Place the hard drive in the bracket and insert 4 screws to secure
the hard drive to the bracket. Place the hard drive and bracket back in the DVR with the power
and data connectors facing the middle and replace the hard drive bracket screws.
Remove the hard drive screws
Remove hard drive bracket
Appendix E: Replacing the Hard Drive
Make sure to hold the hard
drive in place while
removing the hard drive
screws and turning the DVR
to avoid damaging the DVR.
Insert the hard drive screws
Replace hard drive bracket
113