Configuring The Time And Recording Time Display; Configuring Sequence Time; Changing The Video-Out Resolution; Restoring The System's Resolution If You See A Blank Screen - FLIR Digimerge D33084T Instruction Manual

4 Click Apply to save your settings.
Configuring the Time and
Recording Time Display
To add/remove the time stamp in the
system display:
1 In the Live Time and Record Time
drop-down menu, select enable or
disable.
2 Click Apply to save your settings.

Configuring Sequence Time

Sequence time refers to the amount of
time a channel appears on the screen
before changing to a different channel
when the DVR is in Sequence Mode. For
example, when Sequence Mode is on,
channel 1 is shown for several seconds
before switching to channel 2.
To configure the sequence time:
1 Click the Output tab.
2 Click the SEQ Dwell time field and enter
the time channels remains on-screen
before changing to another channel.
3 Click Apply to save your settings.

Changing the Video-out Resolution

1 Click the Output tab.
2 Click the drop-down menu beside VGA
Resolution and select the output
resolution.
SEQ Dwell time
3 Click Apply to save your settings.
4 Right-click repeatedly to exit all menus.
The DVR prompts you to restart. Click OK.
5 The DVR restarts and asks you to confirm
the new resolution. Click Yes to confirm or
No to revert to the old resolution. If you do
nothing, the DVR will revert to the last
selected resolution and restart.
NOTE: If you select a resolution that is
greater than what your monitor
supports, you may see a blank
screen when your DVR restarts. If
this occurs, do not do anything and
wait until the DVR restarts. If the
screen remains blank, press and
hold the Stop button on the remote
control until the DVR restarts. Your
system resolution will default to
1024 x 768.
Restoring the System's Resolution
if you see a Blank Screen
If you see a blank screen on your
monitor after turning on your system,
the DVR's output resolution may be
higher than what your monitor
supports. Follow the steps below to
restore the DVR's default resolution to
1024 x 768.
To restore the DVR's default
resolution:
1 Ensure the power and video cables are
properly connected.
2 Press and hold the Stop button on the
remote control until the DVR restarts. The
DVR will restart with the default resolution
of 1024 x 768.
3 When the DVR restarts, click Yes to
confirm the default resolution.
NOTE: If your system resolution is already
in 1024 x 768, pressing and holding
the Stop button will not restart the
system.

Adjusting Menu Transparency

You can increase or decrease the
transparency of the on-screen menus.
Using the Main Menu
33