Configuring Hard Drive Recording Mode; Configuring Ptz Parameters - FLIR Digimerge D33084T Instruction Manual

Configuring Hard Drive Recording Mode

To configure the hard drive recording mode:
1 Click the Remote Setting tab, and click Device>HDD.
2 In the Overwrite drop-down menu, select Auto to enable overwrite mode. When overwrite is
enabled, the system deletes the oldest footage (first in, first out) when the hard drive is full.

You can also select a desired amount of days or hours the system should retain data. For
example, if you select 30 days, the hard drive will begin to overwrite itself after 30 days. Note
that your hard drive must be large enough to store video for the selected duration.
3 Click Save to apply your settings.

Configuring PTZ Parameters

The system is capable of manipulating PTZ cameras (not included) that are connected to
the system. Please note that you will need PTZ information from the PTZ camera
manufacturer's users guide. For details on connecting a PTZ camera to your system, see
"Appendix B: Connecting a PTZ Camera" on page 104.
To configure PTZ settings:
1 Click the Remote Setting tab, and click Device>PTZ.
2 Configure the following:
• Channel: Select the channel that the PTZ camera connects to.
• Protocol: Select the protocol of the PTZ camera*.
• Baud Rate: Select the baud rate of the PTZ camera*.
Remote Viewing Interface
Overwrite drop-down menu
75