Accessing Your Dvr Within A Local Network (Lan); Step 1 Of 3: Connect Your Dvr To The Local Area Network; Step 2 Of 3: Obtain The Dvr's Local Ip Address - FLIR Digimerge D33084T Instruction Manual

Setting up your DVR for Remote Connectivity

Accessing your DVR within a local network (LAN)

You can connect to your DVR through Internet Explorer through the local area network
(LAN). It is recommended to confirm connectivity over a local network before setting up
your DVR for Internet connectivity.
NOTE: To complete the steps below, your computer must be on the same network as your DVR.
NOTE: Except where noted, the instructions below are the same for PC and Mac.

Step 1 of 3: Connect your DVR to the Local Area Network

1 Power off your DVR by turning the power switch to
2 Connect an Ethernet cable (included) to the LAN port on the rear panel of the DVR. Connect
the other end of the Ethernet cable to a router or switch on your network.
3 Turn the power switch to I to power the DVR back on.
8-channel model shown
INTERNET
(not required for
local viewing)

Step 2 of 3: Obtain the DVR's Local IP Address

1 Press the PTZ/
window.
52
ROUTER
(Not Included)
button on the front panel of the DVR to open the System Information
DVR IP address
HTTP Port

.
Ethernet Cable (included)
COMPUTER
(Not Included)