Table of Contents
Advertisement
AIROC™ Bluetooth® LE module
Regulatory information
RF EXPOSURE:
To comply with FCC RF Exposure requirements, the Original Equipment Manufacturer (OEM) must ensure to
install the approved antenna in the previous.
The preceding statement must be included as a CAUTION statement in manuals, for products operating with the
approved antenna in
Table
7, to alert users on FCC RF Exposure compliance. Any notification to the end user of
installation or removal instructions about the integrated radio module is not allowed.
The radiated output power of CYBLE-3x307x-02 with the trace antenna is far below the FCC radio frequency
exposure limits. Nevertheless, use CYBLE-3x307x-02 in such a manner that minimizes the potential for human
contact during normal operation.
End users may not be provided with the module installation instructions. OEM integrators and end users must be
provided with transmitter operating conditions for satisfying RF exposure compliance.
18.2
ISED
Innovation, Science and Economic Development Canada (ISED) Certification
CYBLE-3x307x-02 is licensed to meet the regulatory requirements of Innovation, Science and Economic Devel-
opment Canada (ISED),
License: IC: 7922A-3072
Manufacturers of mobile, fixed, or portable devices incorporating this module are advised to clarify any
regulatory questions and ensure compliance for SAR and/or RF exposure limits. Users can obtain Canadian infor-
mation on RF exposure and compliance from www.ic.gc.ca.
This device has been designed to operate with the antennas listed in
Table 7 on page
20, having a maximum gain
of –0.5 dBi. Antennas not included in this list or having a gain greater than –0.5 dBi are strictly prohibited for use
with this device. The required antenna impedance is 50 ohms. The antenna used for this transmitter must not be
co-located or operating in conjunction with any other antenna or transmitter.
ISED NOTICE:
The device CYBLE-3x307x-02 including the built-in trace antenna complies with Canada RSS-GEN Rules. The
device meets the requirements for modular transmitter approval as detailed in RSS-GEN. Operation is subject to
the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
L'appareil CYBLE-3x307x-02, y compris l'antenne intégrée, est conforme aux Règles RSS-GEN de Canada.
L'appareil répond aux exigences d'approbation de l'émetteur modulaire tel que décrit dans RSS-GEN.
L'opération est soumise aux deux conditions suivantes: (1) Cet appareil ne doit pas causer d'interférences
nuisibles, et (2) Cet appareil doit accepter toute interférence reçue, y compris les interférences pouvant entraîner
un fonctionnement indésirable.
ISED INTERFERENCE STATEMENT FOR CANADA
This device complies with Innovation, Science and Economic Development (ISED) Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the
device.
Preliminary Datasheet
46 of 58
002-33419 Rev. **
2021-07-22
Advertisement
Table of Contents
