Environmental Specifications; Environmental Compliance; Rf Certification; Safety Certification - Infineon AIROC CYBLE-343072-02 Manual

AIROC™ Bluetooth® LE module

Environmental specifications

17 Environmental specifications
17.1

Environmental compliance

This CYBLE-3x307x-02 Bluetooth® LE module is produced in compliance with the Restriction of Hazardous
Substances (RoHS) and Halogen-Free (HF) directives. The Infineon module and components used to produce this
module are RoHS and HF compliant.
17.2

RF certification

The CYBLE-3x307x-02 module will be certified under the following RF certification standards at production
release.
• FCC: TBD
• CE
• IC: TBD
• MIC: TBD
17.3

Safety certification

The CYBLE-3x307x-02 module complies with the following safety regulations:
• Underwriters Laboratories, Inc. (UL): Filing E331901
• CSA
• TUV
17.4

Environmental conditions

Table 23 describes the operating and storage conditions for the Bluetooth® LE module.
Table 23 Environmental conditions for CYBLE-3x307x-02
Description
Operating temperature
Operating humidity (relative, non-condensation)
Thermal ramp rate
Storage temperature
Storage temperature and humidity
ESD: Module integrated into end system
Components
[24]
Note
24.This does not apply to the RF pins (ANT).
17.5

ESD and EMI protection

Exposed components require special attention to ESD and electromagnetic interference (EMI).
A grounded conductive layer inside the device enclosure is suggested for EMI and ESD performance. Any openings
in the enclosure near the module should be surrounded by a grounded conductive layer to provide ESD
protection and a low-impedance path to ground.
Device handling: Proper ESD protocol must be followed in manufacturing to ensure component reliability.
Preliminary Datasheet
Minimum specification
–30 °C
5%
–
–40 °C
–
–
44 of 58
Maximum specification
85 °C
85%
3 °C/minute
85 °C
85 °C at 85%
15 kV Air
2.0 kV Contact
002-33419 Rev. **
2021-07-22